Installation; Electromagnetic Compatibility - OSD NETWORKS OSD2258EP Operator's Manual

2 INSTALLATION AND OPERATION
2.1 INTRODUCTION
This section outlines the methods required to install and operate the OSD2258EP
successfully. It should be studied carefully if damage to the equipment or poor results are to
be avoided.
This equipment has been fully tested prior to dispatch and is ready for immediate operation.
However, it is advisable to check for external transportation damage before operation. If
damage is evident, return the unit with the packaging to your supplier immediately.

2.2 INSTALLATION

2.2.1 WARNING AND PRECAUTIONS

▲ ELECTROMAGNETIC COMPATIBILITY

WARNING: This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate measures.
▲ OPTICAL OUTPUT OPERATION
WARNING: Laser Safety: Class 1 Laser Product per IEC/EN 60825-1:2014 standard.
PRECAUTIONS
▲ All service personnel should be provided training as to the hazards of direct viewing
of laser radiation and of the precautionary measures during servicing of equipment
▲ Areas where laser products are installed should be restricted in access to trained
service personnel only and appropriate warning signs posted in the work area.
▲ All laser apertures should be covered by protective covers when not connected to
optical fibers. Never leave outputs uncovered.
▲ Laser equipment should be positioned above or below eye level where possible.
Apertures should be positioned away from personnel.
▲ Protective eyewear should be worn in the vicinity of laser equipment.
PAGE 9
Class 1
The OSD2258EP is a Class 1 laser product.
OSD2258EP Operator Manual
10119802