Loading A Program - Cablescan 256/PC Instruction Manual

Model 256/PC Instruction Manual

LOADING A PROGRAM

The LOAD PROGRAM function is divided into two modes, LOAD INTERNAL, and LOAD
CARTRIDGE. These modes are used to load one of the twenty-four stored programs into the
working memory. There are eight locations in internal memory and sixteen in the removable
cartridge. When User Labels are used, the total number of programs decrease by three for each
program saved that contains labels. When all programs have User Labels, there are 2 locations
internal and 4 locations in the cartridge. The program in working memory will be over-written
by the program being loaded.
If the program in working memory is to be retained for future use, save it by means of the Save
Program function before performing this procedure.
inserting the program cartridge.
A complete Load procedure is provided below. Once familiarized, the user may refer to Figure
8. To select and use the Load Program function, proceed as follows:
1. Press Up or Down arrow to step through the menu to display either LOAD INTERNAL
or LOAD CARTRIDGE.
2. Press MENU RUN to initiate the selected mode, and the display will show the signature
for the last program that was selected with the load function:
3. Press Up or Down arrow to display the signature for the program to be loaded into the
working memory. Each time the arrow is pressed, the next program signature will
display. A "Bottom of List" message will appear after all programs have been displayed
using the Down arrow. A "Top of List" message will appear after all programs have
been displayed using the Up arrow.
4. If it is decided not to load the program, press RESET.
5. When the desired program signature is reached, press MENU RUN and the program will
be copied into the working memory.
Load Int (signature #)
or Load Cart (signature #)
Turn power off before removing or
Page 33