Cablescan 256/PC Instruction Manual page 53

Model 256/PC Instruction Manual Page 45
Learn Known Good
This command is used to create a wire list program automatically by scanning a connected
harness assembly and storing the continuities in the working memory. The learned program
overwrites the program that is in the working memory. If the program in the working memory
has not been saved and is to be used later, use one of the save commands before running Learn
Known Good.
Load Internal Program
Use Load Internal Program command to load a stored program from the internal RAM memory
into the working memory. When the LI command is typed followed by an ENTER, the signature
of one of the programs in memory is displayed. Press the letter D to advance down the list of
programs, or press the letter U to advance up the list. The next program signature will display
each time the letter is pressed. To load the program corresponding to the displayed signature,
press ENTER.
Load External Program
Use Load External Program command to load a stored program from the external cartridge
memory into the working memory. When the LX command is typed followed by an ENTER, the
signature of one of the programs in memory is displayed. Press the letter D to advance down the
list of programs, or press the letter U to advance up the list. The next program signature will
display each time the letter is pressed. To load the program corresponding to the displayed
signature, press ENTER.
Save Internal Program
The Save Internal Program command is used to save the program currently in the working
memory into internal RAM memory. If the memory does not have sufficient memory to store
the program, Memory Full is displayed. If there is sufficient memory, Are You Sure? is
displayed. To save the program, press the letter Y.
Save External Program
The Save External Program command is used to save the program currently in the working
memory into external cartridge memory. If the cartridge does not have sufficient memory to
store the program, Memory Full is displayed. If there is sufficient memory, Are You Sure? is
displayed. To save the program, press the letter Y.