Option Installation - YASKAWA SI-N3 Installation Manual

◆

Option Installation

Verify the following installation conditions to make sure that other devices and machinery
used with this option and drive also comply with EMC guidelines:
1.
Use dedicated shield cable for the option and external device (encoder, I/O
device, master), or run the wiring through a metal conduit.
2.
Keep wiring as short as possible and ground the largest possible surface area of
the shield to the metal panel according to
Figure 10.2 Option Installation for CE Compliance: 1000-Series, GA700, GA800
YASKAWA TOEP C730600 84A DeviceNet Installation Manual
10 European Standards
Figure 10.2 and Figure 10.3.
59