Procedure A - YASKAWA SI-N3 Installation Manual

■

Procedure A

This section shows the procedure to install and wire the option on a 1000-series drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive L1000A, U1000 or Z1000U,
make sure that the option software version is PRG: 1112 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure
that the drive functions correctly. Refer to the drive manuals for more information.
A - Insertion point for CN5 connector
B - Option
C - Drive front cover
D - Keypad
E - LED label
F - Drive terminal cover
G - Removable tabs for wire routing
Install the Option
Use this procedure to install the option.
YASKAWA TOEP C730600 84A DeviceNet Installation Manual
Figure 5.1 Drive Components with Option
H - Included screws
I - Ground wire
J - Terminal block (CN1)
K - Drive grounding terminal (FE)
L - Connector CN5-A
M - Connector CN5-B (Not available
for communication option
installation.)
N - Connector CN5-C (Not available
for communication option
installation.)
5 Installation Procedure
17