Procedure D - YASKAWA SI-N3 Installation Manual

5 Installation Procedure
NOTICE
board and the drive. Failure to comply could cause erroneous operation.
Note:
• Replace the keypad connector, then install the keypad.
• Put the keypad connector tab into the holder when you install the keypad connector to the holder.
A - Keypad connector tab
B - Keypad connector
C - Drive front cover
Figure 5.18 Install the LED Status Ring board, Front Cover, and Keypad
7.
Set drive parameters in
performance.
■

Procedure D

This section shows the procedure to install and wire the option on an FP605 drive.
Prepare the Drive for the Option
Before you install the option on an FP605 drive, make sure that the option software
version is PRG: 1115 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure
that the drive functions correctly. Refer to the drive manuals for more information.
32
Do not pinch cables between the front cover or the LED Status Ring
D - Keypad
E - LED Status Ring board
Related Drive Parameters on page 44
YASKAWA TOEP C730600 84A DeviceNet Installation Manual
for correct option