Pushbuttons - Lindy CPU Switch Quad View Installation And Operation Manual

HARDWARE
FRONT PANEL (cont.)
Function of buttons
- BUTTON 1 to 4
- QUAD BUTTON
- PiP BUTTON
Quad View Switch - Installation and Operation Manual
Press these buttons to activate the corresponding channel (computer port) for
keyboard and mouse access and switch to Fullscreen Mode, if Quad Mode is in
operation.
In Fullscreen Mode the PiP function is not affected.
Press this button to activate Quad Mode or return to fullscreen of last selected
channel.
In Fullscreen Mode this button is used to enable or disable the PiP (picture in
picture) function.
In Quad Mode the PiP button is used to open the channel selection window,
where the blue selector points to the active channel. In order to select another
channel press this button repeatedly.
After the expiration of channel selection timeout on a selected computer, the
channel selection window disappears.
The channel selection timeout is configured in OSD under „System -> Quad
Mode". Set the channel timeout to a value from 1 to 30 seconds.
Channel 1
Selector
Channel 3
Channel selection window
Note:
Hotkey P in Quad Mode does the same operation as the PiP button.
Channel 2
Channel 4
INTRODUCTION
= active channel
3