Table of Contents
Advertisement
•
To show the depth from the lowest point of the vessel to the
bottom, set the offset equal to the vertical distance between the
transducer and the lowest part of the vessel, A (negative value).
•
To show the depth from the water surface to the bottom, set the
offset equal to the vertical distance between the transducer and
the water surface, B (positive value)
•
For depth below transducer, set the offset to 0.
Installation
Used for installation and setup. See the separate Installation manual.
Restore echosounder defaults
Restore echosounder settings to the factory supplied defaults.
ForwardScan installation
Available when a ForwardScan transducer is connected.
For setup information, refer to "ForwardScan installation settings" on page
175.
Settings for the 12" units
The 12" GO units can share echosounder data over the Ethernet
network with other 12" GO units, other capable sonar modules and
display units.
Ú Note:
The 12" units cannot share StructureScan 3D data over
the Ethernet network.
The following echosounder settings are available for setting up the
sharing of the data.
Internal Echosounder
When selected, the internal echosounder is available for selection in
the echosounder panel menu.
When unselected, this option disables the internal echosounder in
the unit. It will not be listed as an echosounder source for any unit
on the network. Unselect this option on units which do not have a
transducer connected.
Echosounder
| GO XSE/XSR Operator Manual
157
Advertisement
Table of Contents
