Vessel Settings - Simrad GO XSE Series Operator's Manual

Vessel settings

MMSI
Used for entering your own MMSI (Maritime Mobile Service Identity)
number into the system. You need to have this number entered to
receive addressed messages from AIS and DSC vessels. You also
need to have your MMSI number entered to avoid seeing your own
vessel as an AIS target.
Extension lines
Defines the length of course over ground and heading extension
lines for your own vessel and for other vessels.
The length of the extension lines is set to indicate the distance the
vessel will move in the selected time period.
Your own vessel heading information is read from the active
heading sensor, and COG information is received from the active
GPS. For other vessels COG data is included in the message received
from the AIS system.
Vessels and tracked targets
This dialog contains settings for both AIS and radar targets. Radar
specific settings are only available if you have a capable radar
connected to your system.
Ú Note:
For radar specific settings, refer to "Vessels and tracked targets"
on page 134.
By default, all targets are shown on the panel if an AIS device is
connected to the system. You can select not to show any targets, or
to filter the icons based on security settings, distance, and vessel
speed using this option.
Use this option to specify:
144
AIS | GO XSE/XSR Operator Manual