Simrad GO XSE Series Operator's Manual page 203

Hotspot settings
Select to display the MFD's hotspot network name (SSID) and key.
Only available when the MFD built-in hotspot is turned on.
Remembered hotspots
Displays hotspots the unit has been connected to in the past.
Remote controllers
When a wireless device (smart phone or tablet) is connected, it
should appear in the Remote controllers list. Selecting the always
allow option means the device can automatically connect without
needing to re-enter a password. This dialog also allows you to
disconnect devices that no longer require access.
Wireless devices
This dialog shows the available wireless devices.
Select a device to display additional details.
Advanced
Tools are available within the software to assist in fault-finding and
setting up the wireless network.
DHCP Probe
The wireless module contains a DHCP server that allocates IP
addresses for all the MFDs, and devices in a network. If integrating
with other devices, such as a 3G modem or satellite phone, other
devices in the network may also be acting as DHCP servers. To make
it easy to find all DHCP servers on a network, dhcp_probe may be
run from the unit. Only one DHCP device may be operational on the
same network at a time. If a second device is found, turn off its
DHCP feature if possible. Refer to the device's own instructions for
further assistance.
Ú Note:
Iperf and DHCP Probe are tools provided for diagnostic
purposes by users familiar with network terminology and
configuration. Navico is not the original developer of these
tools, and cannot provide support related to their use.
Internet connection | GO XSE/XSR Operator Manual
203