Removing and replacing an M.2 SSD
Removing and replacing an M.2 SSD
This procedure is for drives on the system board, riser, or expansion card. Do not use this procedure on uFF drives.
Procedure
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Remove the primary riser cage.
6. Remove the M.2 SSD.
To replace the component, reverse the removal procedure.
Removing and replacing an M.2 SSD
71