Removing And Replacing The M.2 Ssd From The Pass-Through Card - HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual

Removing and replacing the M.2 SSD from the pass-through card

Removing and replacing the M.2 SSD from the pass-through card
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION:
Before replacing a DIMM, expansion card, or other similar PCA components due to a perceived hardware error, make
sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards when reseating components.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 SSD air baffle.
9. If the expansion card installed in the riser slot 1, remove the riser cage.
10. Remove the M.2 pass-through card assembly:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Detach the M.2 pass-through card assembly from the chassis (callout 2).
Removing and replacing the M.2 SSD from the pass-through card 112