Re-Entering The Server Serial Number And Product Id - HP HPE ProLiant DL365 Gen10 Plus Maintenance And Service Manual

Re-entering the server serial number and product ID

Re-entering the server serial number and product ID
After you replace the system board, you must re-enter the server serial number and the product ID.
Procedure Procedure
1. During the server startup sequence, press the F9 key to access UEFI System Utilities.
2. Select the System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options > Advanced System ROM Options >
Serial Number, and then press Enter.
3. Enter the serial number and press Enter. The following message appears: The serial number should only be
modified by qualified service personnel. This value should always match the serial
number located on the chassis.
4. Press Enter to clear the warning.
5. Enter the serial number and press Enter.
6. Select Product ID. The following warning appears: Warning: The Product ID should ONLY be modified by
qualified service personnel. This value should always match the Product ID located on
the chassis.
7. Enter the product ID and press Enter.
8. Press the F10 key to confirm exiting System Utilities. The server automatically reboots.
Re-entering the server serial number and product ID 117