Removing And Replacing The M.2 Sata Ssd Add-In Card - HP ProLiant DL345 Gen10 Plus Maintenance And Service Manual

Removing and replacing the M.2 SATA SSD add-in card

Removing and replacing the M.2 SATA SSD add-in card
Prerequisites Prerequisites
Before you perform this procedure, make sure that you a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel .
5. Disconnect any internal cables that are connected to the expansion board.
6. Remove the riser cage.
7. Remove the M.2 SATA SSD add-in card.
8. Remove the M.2 SATA SSD.
Removing and replacing the M.2 SATA SSD add-in card 111