Removing And Replacing A 940Qsfp56 X16 Adapter And Auxiliary Card - HP HPE ProLiant DL365 Gen10 Plus Maintenance And Service Manual

Removing and replacing a 940QSFP56 x16 adapter and auxiliary card

Removing and replacing a 940QSFP56 x16 adapter and auxiliary card
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Remove the riser cage (Removing and replacing a riser cage).
6. Remove the auxiliary card from slot 3 ( Removing and replacing an expansion board ).
7. Disconnect the cables to the auxiliary card:
a. Open the retention clip and slide it away from the connectors.
b. Gently pull up the top corner of the cable latch door.
c. Disconnect the card cables.
8. Remove 940QSFP56 x16 adapter from slot 2 ( Removing and replacing an expansion board ).
9. Disconnect the cables to the 940QSFP56 x16 adapter.
To replace the component:
1. Thread the adapter end of the auxiliary card cables through one of the retention clips provided with the installation kit.
2. Open the cable latch door, connect the auxiliary card cables to the 940QSFP56 x16 adapter ports so that the golden side of the
cable connector is on the top, and then close the cable latch door.
The white and black cables from the auxiliary card connect to the expansion board ports labeled WHITE CABLE and BLACK CABLE,
respectively.
Removing and replacing a 940QSFP56 x16 adapter and auxiliary card 88