Table of Contents
Advertisement
2. If needed, install expansion boards (Installing an expansion board in the secondary riser cage on
page 77).
3. Install the access panel (Installing the access panel on page 25).
4. Install the server into the rack (Installing the server into the rack on page 36).
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server (Powering up the server on page 24).
Removing the 8 SFF drive backplane
Procedure
1. Back up all server data.
2. Power down the server (Power down the server on page 24).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
5. Remove the access panel (Remove the access panel on page 25).
6. Remove all drives (Removing a hot-plug SAS or SATA hard drive on page 47).
7. Disconnect and remove all cables connected to the drive backplane.
8. Remove the 8 SFF SAS/SATA drive backplane.
30
Removing the 8 SFF drive backplane
Advertisement
Table of Contents
