Advertisement
Saber Spot WW
Software Update
Please Wait ...
Display Menu
ADJ
SOFTWARE V1.0 3
About LED protection ：
Special Remark:
When reach 65 degree, the power consumption is reduced to 82%. When the sensor is
damaged, the power consumption is reduced to 65%.
SN
MENU DISPLAY
DMX MODE
1
ADDR ：001
2
CHANNNEL 4CH
Secondry
3
LOOK
4
Store:01
Reset ？
5
NO
Manual
6
W 000- 255 S 000- 255
DimCurve
7
Standard
NO DMX
8
Hold
9
TempUnit
10
Temp Val
11
AUTOLOCK
12
IR Active
13
FlipDisplay
ADJ Products, LLC - www.adj.com - Saber Spot WW Instruction Manual Page 8
System Menu
FUNCTION
Address setting
001- 512
1/2/4CH(see channel mode)
Secondary mode
Store mode 01- 13
Yes,press ENTER to resume the factory
default setting
Manual dimmer
W 000- 255 strobe ：S000- 255
5 kinds Dimmer curve
Standard,
Stage, TV, Architec,
Theatre
No DMX mode
Blackout,
Hold, LOOK
C/F
Temperature show: xxx F
Display keylock
OFF/ON
IR setting
OFF/ON
Flip display
OFF/ON
Saber Spot WW
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
DMX MODE -
DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "DMX
MODE" is displayed, press ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
CHANNEL -
This will let select your desired DMX
channel mode.
1. Press the either the MENU button until "CHANNEL" is dis-
played, press ENTER. The current DMX channel mode will be
displayed.
2. Press the UP or DOWN buttons to find your desired DMX
channel mode and press ENTER to confirm and exit.
SECONDARY -
This will let you set the unit as the
secondary in a primary/secondary configuration.
1. Press the MENU button until "SECONDARY" is
displayed, press ENTER.
LOOK -
In this mode you can run a show mode.
1. Press the MENU button until "LOOK" is displayed, press
ENTER.
2. Use the UP or DOWN buttons to find your desired mode.
ADJ Products, LLC - www.adj.com - Saber Spot WW Instruction Manual Page 9
System Menu
Advertisement
