Calibration Submenu - Kohler 500EOZCS Operation

1.8.3

Calibration Submenu

The calibration values are reviewable at all times and
provide the calibration of the voltage and current
sensing logic. Changing the system voltage or
replacing the circuit board requires a calibration
adjustment.
Note: Have calibration adjustments performed by an
authorized Kohler distributor/dealer.
To enable calibration, when the line is highlighted, push
and hold the pushbutton/rotary selector dial to enable
the calibration capability. The user is prompted with a
Yes/No prompt for calibration. The display will show the
following:
Gen L1- L0 Volts
D
Gen L2- L0 Volts
D
Gen L3- L0 Volts
D
Gen L1- L2 Volts
D
Gen L2- L3 Volts
D
Gen L3- L1 Volts
D
Gen L1 Current
D
Gen L2 Current
D
Gen L3 Current
D
Bus L1- L2 Volts
D
Bus L2- L3 Volts
D
Bus L3- L1 Volts
D
Reset Gen Volt Meter: (Yes/No)
D
Reset Gen Amp Meter: (Yes/No)
D
Reset Bus Volt Meter: (Yes/No)
D
Reset All Meters: (Yes/No)
D
36 Section 1 Specifications
The user can change individual values or can select the
individual Reset to reset certain values. The Reset
selections will only show if calibration is enabled. Refer
to the requirements shown with Generator Set
Calibration in 2.6.5 Status and Notice Digital Displays.
TP-7126 5/20