Introduction; Controller Specifications; Decision-Makerr 3500 Controller Information - Kohler 500EOZCS Operation

1.2 Introduction

The spec sheets for each generator set provide model-
specific generator and engine information. Refer to the
respective spec sheet for data not supplied in this
manual. Refer to the generator set service manual,
installation manual, engine operation manual, and
engine service manual for additional specifications.

1.3 Controller Specifications

Decision-Makerr 3500
Power source with
circuit protection
Power drain
Humidity range
Operating temperature
Storage temperature
Note: Have setup
Decision-Makerr 3500 controller performed only
by an authorized Kohler distributor/dealer. The
setup and adjustments are password protected.
TP-7126 5/20
24-volt DC
200 milliamps at 24V
5- 95%
- 40_ to 70_C (- 40_ to 158_F)
- 40_ to 85_C (- 40_ to 185_F)
and adjustments of
1.4 Decision-Makerr 3500
Controller Information
The following data must be resident for the controller to
function.
Application program contains the software that
D
controls system operation. The application file was
preprogrammed in the original controller at the
factory.
Personality profile is specific to the engine and
D
alternator and was preprogrammed in the original
controller at the factory.
A backup disk of the personality profile and
application program is supplied in the junction box of
the generator set. Typically, the Kohler authorized
distributor/dealer passes this disk onto the owner.
The owner should store this disk for possible future
use such as controller replacement or other
the
circumstances requiring a backup.
Note: If the personality disk is NOT available, request
a replacement from Kohler Co. using the
generator set serial number or order number.
User parameters unique to an installation include
D
timer values, setpoints, generator set data such as
voltage and
parameters are typically set up for or by the installer at
the time of installation. User parameters are typically
recorded on the personality profile disk, a separate
backup disk/drive, or written on a paper form.
Note: If the user parameters are included on the
personality disk, the disk label should indicate
Site Program—Yes.
Note: After the unit is set up on the vessel, Kohler
authorized distributor/dealer saves any user
parameter changes to an external medium.
Kohler authorized distributor/dealer passes
this information onto the owner. The owner
should store this information for possible future
use such as controller replacement or other
circumstances requiring a backup.
Note: Controller service replacement kits do not
include the three files. The service technician
must install the three files into the replacement
controller.
input/output selections.
Section 1 Specifications
These
17