Dell EMC Edge Gateway 5200 Service Manual page 4

Hide thumbs Also See for EMC Edge Gateway 5200:

About this task

Installation of the SSD requires removal of the bottom panel, and the SSD bracket is preinstalled in the EGW-5200.

Steps

1. Remove the eight screws from the bottom panel of the EGW-5200, as shown in the following figure, and remove the bottom

panel.

Figure 1. Bottom panel screw locations

NOTE:

If 4G or 5G is installed, you must also remove the remaining four screws.

2. Remove the four screws of the SSD bracket, as shown in the following figure.

Installation procedure for SSD