Gas Test/Wire Threading Control Panel (Optional) - Fronius Pull Operating Instructions Manual

(9)
(10)
Side view
Gas test/wire
threading con-
trol panel (op-
tional)
No.
(2)
(3)
72
Blanking cover for option 2
Wire infeed
(2)
(1) (3)
Function
Gas-test button
For setting the required gas flow rate on the pressure regulator
- Gas will flow out for 30 seconds after the gas-test button is pressed.
Press the button again to stop the gas flow prematurely
Wire retract button
For retracting the wire electrode with no accompanying flow of gas or cur-
rent
- While the button is being pressed, the wirefeeder runs at the preset
wire retract speed
The wire electrode can be retracted using one of two methods:
Method 1
Retracting the wire electrode using the preset wire retract speed:
No. Function
(11) Cover
(12) Bushing
(13) Gas test / wire threading con-
trol panel (option)
No. Function
(1) Operating status LED
Shows steady green when the
device is ready for use
(4)