Remote Connection; Audio Output (Line Level); Front Panel Features; Mounting The Mlp 101 - Extron electronics mlp 101 series User Manual

MLP 101, cont'd

Remote connection

d
Remote — An optional 3-pin, captive screw connector allows
a wall mounted audio controller or MediaLink product to
remotely control volume and mute levels for the MLP 101
unit. See "Remote Control", later in this chapter, for more
information.

Audio output (line level)

e
Line Output — A 3-pin, captive screw connector outputs to
audio mixers, amps switchers, or other non-microphone audio
equipment.
0.2"
(5 mm) MAX
Captive Screw
Connector stripping
Tip
Ring
Sleeve
Balanced Output

Front Panel Features

MIC GAIN
(dB)
LOW CUT PHANTOM
ON
OFF
25 72
MLP 101
1 2 3 4
a
Power LED — This LED lights green to indicate that the unit is
receiving power.
b
Mic Gain — A recessed, adjustable pot defines the amount of
input signal (between 25 and 72 dB) allowed into the preamp.
c
Low Cut filter switch — Provides switchable low cut filtering to
remove wind and "table rumble" noise.
d
Phantom power switch — Provides switchable 48 volt phantom
power for condenser microphones.
MLP 101 Series • MLP 101
2-4
CAUTION
For unbalanced audio, connect the sleeve(s)
to the ground. DO NOT connect the sleeve(s)
to the negative (-) contact.
Tip
NO Ground Here
Sleeve
Unbalanced Output
(high impedance)

Mounting the MLP 101

There are many optional accessories for mounting the MLP 101.
They include the following:
Projector mounting options
• PMK 100 Mini Projector
• PMK 300 Multi-Product Projector (part #70-374-01 )
• PMK 350 Low Profile Multi-Product Projector
Rack mounting options
• RSF 123 1U 3.5" Deep
• RSB 123 1U 3.5" Deep Basic
• RSU 126 1U 6" D Universal
• RSB 126 6" Deep Basic
• RSU 129 1U 9.5" Deep Universal
• RSB 129 1U Basic
• MBB 100 Back of Rack Mount
Furniture mounting option
• MBU 123 Mini Under-Desk
The MLP 101 can be set on a table, mounted on a rack shelf,
or mounted under a desk or table. Following are detailed
instructions for these mounting options.

Tabletop use

The MLP 101 comes with four self-adhesive rubber feet (not
attached). For a tabletop installation, do the following:
1. Attach the rubber feet to the underside of the MLP 101
near the corners of the unit.
2. Place the MLP 101 unit in the desired location.
(part #70-217-01)
(part #70-563-02/03 )
(part #60-190-20)
(part #60-604-20)
(part #60-190-10)
(part #60-604-10)
(part #60-190-01)
(part #60-604-01)
(part #70-367-01)
(part #70-212-01)
MLP 101 Series • MLP 101
2-5