Table of Contents
Advertisement
1
• The red indicator light next to the UPPER SHELF label indicates that the temperature being
displayed is for the selected cavity.
• The red indicator light next to the PROG label blinks when in the Programming Mode.
• The red indicator light next to the LOWER SHELF label indicates that the temperature
being displayed is for the selected cavity.
• The red indicator light next to the HEAT label is on when power is applied to the heater
zone being displayed on the control panel.
• The red indicator light next to ACTUAL TEMP label is on when the Actual Temperature is
being displayed for the heater zone being displayed on the control panel.
• The red indicator light next to SET-POINT TEMP label is on when the Set-Point
Temperature is being displayed for the heater zone being displayed on the control panel.
• The digital display shows the shelf and the associated temperature for each heater, for
example:
The display for the upper shelf may show A235 for the UPPER HEATER.
2
• SET-POINT: The Set-Point temperature is displayed for the selected
heaters when this button is pressed during the operating mode. The
SET-POINT indicator light is on when the Set-point mode is selected.
• To Program a heater, press and hold the PRINCE CASTLE button then
press and hold the SET-POINT button for 5 seconds or until the PROG
indicator light turns on. Use the UP and DOWN arrows to change the
Set-Point temperature.
Upper/Ceiling Heaters in Both Shelves — Programmed for Temperature
1
The temperature of the Upper Heaters can be adjusted from 150 to 350°F
(65.6 to 176.7°C) in one-degree increments (Fahrenheit).
1. Use the UP or DOWN arrow buttons to select Heater A through D in
UPPER or LOWER SHELF.
2. Press the SET-POINT button. When the SET-POINT indicator light is
on, the digital display shows the Set-Point temperature.
540-517revK-EN
Control Panel
Displays and Indicators
Control Panel Buttons
• ACTUAL TEMP: The Actual Heater temperature is displayed only for
the selected heater when this button is pressed in the operating mode.
• UP ARROW & DOWN ARROW: When pressed in the operating mode,
selects which heater is in the display on the control panel. The indicator
light next to the UPPER SHELF or LOWER SHELF is on to indicate
which shelf is selected.
Programming
3. To change the temperature setting, press and hold the PRINCE
CASTLE LOGO button; then press and hold the SET-POINT button.
Hold both buttons until the PROG indicator light turns on.
4. Use the UP and DOWN arrow buttons to change the temperature.
5. Press the PRINCE CASTLE LOGO button to store the new value and
to exit the PROGRAMMING mode.
Repeat steps 1 – 5 for other
Heaters in both upper and
lower shelves.
9
Product Holding Bin
DHB2PT-YUM Series
Control Panel
Printed in USA 1/09 © 2009
Advertisement
Table of Contents
