Advertisement
INSTALLATION
1. After you have removed the Bin from the carton,
inspect the unit for signs of damage. If there is
damage to the unit:
Notify carrier within 24 hours after delivery.
Save carton and packing materials for inspection
purposes.
Contact the Prince Castle Customer Sales
Department at 1-630-462-8800 to arrange for
a replacement to be sent.
1. Place the bin on a counter and seal its base to
the counter with food-approved sealant.
2. Insert the power cord into a proper voltage
receptacle. Note: This should be a dedicated
outlet. No other equipment should be operating
on this line (i.e. fryers, refrigerators, etc.)
3. Turn the power switch on. Allow 20 minutes for
warm-up.
RECOMMENDED STARTING
TEMPERATURES
1. Temperature settings:
There are two holding cavities, the top cavity is
used to hold sides and the bottom cavity holds
biscuits. There is a top heater and a bottom
heater in each cavity. The temperature of each
heater can be set independent of each other.
The recommended starting temperature for each
heater is 180°F.
THE CONTROL PANEL
1A
1B
1C
1E
1F
1.
Display
1A The LED indicator next to the
UPR SHELF indicates that the tempera-
ture being displayed is for a heater in the
upper cavity.
Printed in USA 1/06 © 2006
1B The LED indicator next to the PROG is on
1C The LED indicator next to the LWR
1D The LED indicator next to the HEAT is on
1E The LED indicator next to ACTUAL
1F The LED indicator next to SET POINT
2.
Control Panel buttons
•
•
•
1D
PROGRAMMING
The temperature adjustment range for a heater zone
is: OFF, 150°F to 275°F. The recommended starting
setpoint temperature for all four heaters is 180°F.
Use the following procedure to change a setpoint
temperature.
2
when in the Program Mode.
SHELF indicates that the temperature
being displayed is for the a heater in the
lower cavity.
when power is applied to the heater.
TEMP is on when the Actual Temperature
is being displayed.
TEMP is on when the Set Point Tempera-
ture is being displayed.
SET POINT: The set-point temperature is
displayed for the selected heaters when
this button is pressed during the operat-
ing mode. The SET POINT LED indicator
in the display will be on when the Set-
point mode is selected. Press and hold
the Prince Castle button then press and
hold the SET-POINT button for 5 seconds
to program the temperature for the se-
lected heater.
ACTUAL TEMP: The actual temperature
is displayed for the selected heaters
when this button is pressed during the
operating mode. The ACTUAL TEMP
LED indicator in the display will be on
when the Set-point mode is selected.
UP ARROW and DOWN ARROW: When
pressed in the operating mode, the
display will scroll through the tempera
tures of the heaters. The LED next to
the UPR SHELF or LWR SHELF will be
on to indicate which cavity is being
selected. The letter U or L is displayed
for the Upper or Lower heater in the
selected cavity.
528-500revA
Advertisement
