Advertisement
Quick Links
Operation
Manual
LIMITED WARRANTY
This product is warranted to be free from defects in material and/or
workmanship for a period of 1 year from date of original installation, not to
exceed 18 months from the date of manufacture.
Any component which proves to be faulty in material and/or workmanship
will be replaced or repaired (at the option of Prince Castle, Inc.) without
cost to the customer for parts and labor. This warranty covers on-location
service (i.e. trip charges and/or mileage). Travel mileage is limited to
100 miles (200 Kilometers) round trip (one trip warranty) from an
authorized service agency or its sub-service agency.
This warranty is subject to the following exceptions/conditions:
• Use of any non-genuine Prince Castle parts voids this warranty.
• All labor to be performed during regular work hours. Overtime premium
(the incremental amount) will be charged to the customer.
• Damage caused by carelessness, neglect and/or abuse (e.g.,
dropping, tampering, or altering parts, equipment damaged in
shipment, by fire, flood or an act of God) is not covered under this
warranty.
• All problems due to operation at voltages other than that specified on
equipment nameplates are not covered by this warranty. Conversion to
correct voltage is the customer's responsibility.
• Normal adjustments as outlined in this manual are not covered under
warranty.
• This equipment must be serviced by Prince Castle Authorized Service
Agency or a Prince Castle Service Technician during the warranty
period.
540-523_EN rev.D
Product Identification
Product Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electrical Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initial Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resetting to Factory Defaults . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Setting Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using Pan Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Calibrating Heaters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Exploded View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
355 East Kehoe Blvd. • Carol Stream, IL 60188 USA
Telephone: 630-462-8800 • Toll Free: 1-800-PCASTLE
Fax: 630-462-1460 • www.princecastle.com
Product Holding Bin
DHB2PT-20PUBGBN
Temperature
Control Panel
UPPER
SHELF
PROG
HEAT
LOWER
SHELF
ACTUAL
TEMP
SET-
POINT
P
RINCE
C
ASTLE
Power On/Off
Switch
TABLE OF CONTENTS
Printed in USA 6/10 © 2019
1
2
2
2
2
2
3
3
3
4
4
5
5
6
7
Advertisement
Related Manuals for Prince Castle DHB2PT-20PUBGBN
Summary of Contents for Prince Castle DHB2PT-20PUBGBN
-
Page 1: Table Of Contents
Installation ..........will be replaced or repaired (at the option of Prince Castle, Inc.) without Initial Startup . -
Page 2: Safety Information
Prince Castle for more information. defaults! Use with caution. Prince Castle reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. -
Page 3: Operation
Used with other buttons to scroll through heater selected. and temperature selections. ACTUAL TEMP BUTTON and LED PRINCE CASTLE LOGO BUTTON Press to display actual temperature for the selected heater. LED will be lit and actual Press to program temperature selections. -
Page 4: Using Pan Cover
SET-POINT indicator light is on when the Set-point mode is selected. • UP ARROW & DOWN ARROW: When pressed in the operating mode, • To Program a heater, press and hold the PRINCE CASTLE button then selects which heater is in the display on the control panel. The indicator... -
Page 5: Programming
4. Use the UP and DOWN arrow buttons to change the temperature. 2. Press the SET-POINT button. When the SET-POINT indicator light is 5. Press the PRINCE CASTLE LOGO button to store the new value and on, the digital display shows the Set-Point temperature. -
Page 6: Exploded View
Product Holding Bin DHB2PT-PUBGBN Exploded View Ref. Description 540-1046S Upper Heater 540-762S Upper Shelf, Lower Rope Heater 72-428S Power Cord Assy. 540-760S Base (Rope Heater) 78-184S Power Switch 542-455S Main Brd. 541-719S Display PCB 540-809S Printed in USA 6/10 © 2019 540-523_EN rev.D... -
Page 7: Wiring Diagram
Product Holding Bin DHB2PT-PUBGBN Wiring Diagram 540-523_EN rev.D Printed in USA 6/10 © 2019...