Replacement Of Main Parts; Tightening Torque - Sony ODS-D280U Service Manual

Note
Be sure to turn off the power switch and unplug the power cable from the DC power input connector before disassembling
parts. Before turning on the power after assembly, be sure to confirm that the cabinet parts is installed. Failure to do so
may cause injury due to irradiation of Class 3B laser.
4-1.

Tightening Torque

When tightening screws used in this unit, be sure to use a torque driver and tighten screws to the specified tightening
torque.
If the specified tightening torque is described in the figure in this section, tighten screws to the specified tightening
torque in the figure.
Standard torque
Screw type
P2 x 5
B2.6 x 4
B2.6 x 14
Special head machine screw M2 (except for CA arm L cover assembly and CA arm
R lower cover)
Special head machine screw M2 (CA arm L cover assembly and CA arm R lower
cover)
PSW2 x 5
Shoulder screw
M1.4 x 1.6
M1.7 x 3
Tip
When using the torque driver with the notation of cN·m, interpret it as follows.
Example: 0.8 N·m = 80 cN·m
ODS-D280U/ODS-D280F
Section 4

Replacement of Main Parts

Torque
0.20 ±0.02 N·m
0.40 ±0.04 N·m
0.40 ±0.04 N·m
0.20 ±0.02 N·m
0.10 ±0.02 N·m
0.20 ±0.02 N·m
0.30 ±0.03 N·m
0.10 ±0.02 N·m
0.10 ±0.02 N·m
4-1