Table of Contents
Advertisement
4-24.
Roller Gear Assembly
Preparation
1.
Remove the top cover assembly. (Refer to
2.
Remove the bottom plate assembly. (Refer to
3.
Remove the MC top reinforcing plate. (Refer to
4.
Remove the RE rear assembly. (Refer to
5.
Remove the power block. (Refer to
6.
Remove the carry loader assembly. (Refer to
7.
Remove the CA upper assembly. (Refer to
8.
Remove the CA upper BU assembly. (Refer to
9.
Remove the CA middle loader assembly. (Refer to
Procedure
1.
Slide the portions (g) of the CA middle slider L assembly and CA middle slider R assembly in the direction of the
arrow (A) so that the return arm becomes popped out state.
Portion
(g)
(A)
2.
Remove the four screws, then remove the CA middle arm plate assembly.
3.
Remove the two screws, then remove the CA arm R lower cover.
ODS-D280U/ODS-D280F
"4-2. Top Cover
"4-3. Bottom Plate
"4-4. MC Top Reinforcing
"4-7. RE Rear
"4-8. Power Supply
"4-11. Carry Loader
"4-14-1. CA Upper
"4-14-2. CA Upper BU
"4-15. CA Middle Loader
CA middle slider L assembly
Return arm
n
Be careful not to deform
the return arm.
Assembly".)
Assembly".)
Plate".)
Assembly".)
Block".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
CA middle loader assembly
CA middle slider R assembly
Portion
(A)
(g)
4-56
Advertisement
Table of Contents
