Table of Contents
Advertisement
Code
Description
04-17C
Optical block assembly
OP-1 cannot move to the in-
nermost circumference of
the disc. (On side 0)
06-E41
The SA actuator of optical
block assembly Ch-0A can-
not detect the reference posi-
tion. (On side 0)
06-EC1
The SA actuator of optical
block assembly Ch-0B can-
not detect the reference posi-
tion. (On side 0)
06-F41
The SA actuator of optical
block assembly Ch-1A can-
not detect the reference posi-
tion. (On side 0)
ODS-D280U/ODS-D280F
Error remedy method
1.
Eject a cartridge.
2.
Startup the maintenance menu and perform
SLIDER AUTO TEST.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Check the main base assembly installation
status and the carry loader assembly instal-
lation status.
4.
Check the flexible flat cable connection be-
tween the main base assembly and the
DR-683 board.
If this problem still remains, any abnormality may
be present in the slider of the optical block assem-
bly (OP-1) or the DR-683 board may be defective.
1.
Eject a cartridge.
2.
Startup the maintenance menu and perform
SA ACTUATOR.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Check the flexible flat cable connection be-
tween the main base assembly and the
DR-683 board.
If this problem still remains, the optical block as-
sembly (OP-0) or the DR-683 board may be de-
fective.
1.
Eject a cartridge.
2.
Startup the maintenance menu and perform
SA ACTUATOR.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Check the flexible flat cable connection be-
tween the main base assembly and the
DR-683 board.
If this problem still remains, the optical block as-
sembly (OP-0) or the DR-683 board may be de-
fective.
1.
Eject a cartridge.
2.
Startup the maintenance menu and perform
SA ACTUATOR.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Check the flexible flat cable connection be-
tween the main base assembly and the
DR-683 board.
If this problem still remains, the optical block as-
sembly (OP-1) or the DR-683 board may be de-
fective.
Refer to section
"4-11. Carry Loader Assembly"
"4-30. Main Base Assembly"
"6-4-6. SLIDER AUTO TEST"
"4-30. Main Base Assembly"
"6-4-8. SA ACTUATOR"
"4-30. Main Base Assembly"
"6-4-8. SA ACTUATOR"
"4-30. Main Base Assembly"
"6-4-8. SA ACTUATOR"
Continued
2-20
Advertisement
Table of Contents
