Table of Contents
Advertisement
2.
When the [DOWN] button is clicked, the result of optical block assembly OP-1 is displayed.
Furthermore when the [DOWN] button is clicked, the result optical block assembly OP-2 and OP-3 is displayed
in the order.
TIMERS-2
OP-1
S NO 202016071130011
SEEK COUNT
03297T
LASER ACH
00269
LASER BCH
00268
NEXT PAGE: DOWN KEY
PREV PAGE:
UP KEY
EXIT: MENU KEY
Tip
When the [UP] button is clicked, returns to the previous page.
6-7-8.
RESET HOURS
This menu is used to reset the digital hours meter.
The following describes procedure for total rotation time of spindle motor (Spindle Running Hours) reset. About the
reset of the other hours meter data, select an applicable item in step 2 below.
Menu hierarchy
[OTHERS]
[RESET HOURS]
Procedure
1.
Select the "RESET HOURS" and then click the [RIGHT] button.
The hours meter data that can be reset is displayed.
DRIVE MAINTENANCE
OTHERS
RESET HOURS
>
RESET SPINDLE HOURS
RESET SELECT COUNT
RESET CARRY COUNT
RESET SEEK COUNT
RESET DISC GUIDE CT
RESET CA MOTOR H CT
RESET CA MOTOR V CT
2.
Select the "RESET SPINDLE HOURS" and the click the [RIGHT] button.
A confirmation window appears waiting for entry of the [SET] button.
RESET SPINDLE HOURS
ARE YOU SURE?
OK: SET KEY
EXIT: MENU KEY
ODS-D280U/ODS-D280F
TIMERS-2
OP-2
S NO 202016070730006
SEEK COUNT
03292T
LASER ACH
00265
LASER BCH
00273
NEXT PAGE: DOWN KEY
PREV PAGE:
UP KEY
EXIT: MENU KEY
TIMERS-2
OP-3
S NO 202016071130015
SEEK COUNT
03293T
LASER ACH
00269
LASER BCH
00268
PREV PAGE:
UP KEY
EXIT: MENU KEY
6-28
Advertisement
Table of Contents
