Table of Contents
Advertisement
4-30-1.
Attaching of BU Thread Guard 2
Procedure
1.
Make a crease along the perforation of the BU thread guard 2 as shown in the illustration.
2.
Wrap the BU thread guard 2 around the harness (12V-DR) in the order of (1) and then (2).
3.
Peel the release paper (side) and attach together.
Tip
Move the BU thread guard 2 back and forth to check that it moves freely.
4.
Move the BU thread guard in the direction of the arrow until it hits the JS DR radiation plate.
5.
Peel the release paper (rear side), then attach it to the main base assembly.
Release paper (side)
(1)
BU thread guard 2
BU thread guard 2
Harness (12V-DR)
Release paper (rear side)
ODS-D280U/ODS-D280F
Perforation
Perforation
(2)
Release paper (rear side)
JS DR
radiation plate
CA lower BU
Harness (12V-DR)
The attached portion should not
protrude from the CA lower BU.
BU thread guard 2
Black tape
Harness (12V-DR)
The clearance
between the crease
and overlapped portion is 0 to 3 mm.
Motor
BU thread guard 2
Release paper
(rear side)
A clearance should be provided
between the BU thread guard 2
and motor.
The end of BU thread guard 2
should ride on the DR board.
4-74
Advertisement
Table of Contents
