4-9.
Fan 40 Assembly (RP) and Fan 60 Assembly (RP)
Tip
The following part cannot be reused. Prepare the new part.
• JS fan S dust-proof sheet: 1pc
Preparation
1.
Remove the top cover assembly. (Refer to
2.
Remove the bottom plate assembly. (Refer to
3.
Remove the MC top reinforcing plate. (Refer to
4.
Remove the RE rear assembly. (Refer to
5.
Remove the power supply block. (Refer to
Procedure
1.
Remove the fan 40 assembly (RP).
(1) Disconnect the harness from the connector (CN1) on the PP-61 board, then remove the fan 40 assembly (RP)
and JS fan S dust-proof sheet.
Note
• When attaching the fan 40 assembly (RP), pay attention to the positions of the label and harness.
• Be careful that the JS cushions (FAN) are not peeled off.
ODS-D280U/ODS-D280F
"4-2. Top Cover
"4-3. Bottom Plate
"4-4. MC Top Reinforcing
"4-7. RE Rear
"4-8. Power Supply
Power supply block
Fan 40 assembly (RP)
CN1
JS cushion (FAN)
PP-61 board
JS fan S dust-proof sheet
Assembly".)
Assembly".)
Plate".)
Assembly".)
Block".)
JS cushion (FAN)
Label side
4-17