Note
Be sure to turn off the power switch and unplug the power cable from the DC power input connector before disassembling
parts. Before turning on the power after assembly, be sure to confirm that the cabinet parts is installed. Failure to do so
may cause injury due to irradiation of Class 3R laser.
5-1.
Upper Plate Assembly
Procedure
1.
Remove the nine screws to detach the upper plate assembly.
Note
When removing the upper plate assembly, be careful not to damage the fine-wire coaxial cable.
Fine-wire coaxial
cable
Upper plate
Portion A
B2.6 x 4
(c)
Front panel
Note
Pay attention to the following when installing the upper plate assembly.
• Insert portion A into under the front panel first.
• Tighten screws in the order of (a), (b), and (c).
2.
Install the removed parts by reversing the steps of removal.
ODS-D77U/ODS-D77F
Section 5
Replacement of Main Parts
Upper plate assembly
B2.6 x 4
(b)
B2.6 x 4
B2.6 x 4
(a)
(b)
B2.6 x 4
(c)
5-1