Table of Contents
Advertisement
Code
Description
20-901
Operation of the select arm
mechanism did not end with-
in the specified time period
during disc unloading opera-
tion.
*1:
For the ODS-D280F, perform "Eject" operation from the PC (or host device) or press the EJECT button on the rear of the drive to eject
the cartridge.
Note
EJECT button operation or power off/on operation may generate another alarm code.
ODS-D280U/ODS-D280F
Error remedy method
1.
Press the EJECT button to eject the car-
tridge.
*1
If the cartridge is not ejected, take the fol-
lowing measures.
•
Turn off and on the drive. Press the
EJECT button after startup to eject the
cartridge.
•
If the cartridge is not ejected even after
this operation, eject it manually.
2.
Visually check the cartridge.
•
If an abnormality (such as bulge) is
found, do not use the cartridge any lon-
ger and go to step 4) in Measures.
Tip
For how to handle the defective car-
tridge, contact your local Sony Sales
Office/Service Center.
3.
Insert the same cartridge and check whether
this error occurs again.
If the cartridge cannot be inserted, turn off
and on the drive and then insert the cartridge
again.
•
When this error occurs again, go to
step 4) in Measures.
•
When this error no longer occurs, use
the unit as it is.
4.
Insert another cartridge and check whether
this error occurs again.
•
When this error no longer occurs,
check the following.
-
When this error occurs again by
checking shown in step 3) in
Measures, the previous cartridge
may be defective.
Do not use the previous cartridge
any longer.
Tip
For how to handle the defective
cartridge, contact your local So-
ny Sales Office/Service Center.
-
When this error no longer occurs
by checking shown in step 3) in
Measures, use the unit as it is.
•
When this error occurs again, the se-
lect loader assembly may be defective.
Refer to section
"1-10. How to Eject the Car-
tridge (ODS-D280F)"
"1-11. How to Eject the Car-
tridge Manually"
"4-10. Select Loader Assembly"
Continued
2-39
Advertisement
Table of Contents
