Table of Contents
Advertisement
Measures
If indication cannot be checked in Check (1) and Check (2) or when a [!], [?], or [x] mark is attached in the device list,
perform the following procedure to check whether the indication of Device Manager becomes normal.
1.
Restarting the drive:
(1) Check the serial number of the drive shown by the utility software (Optical Disc Archive Utility).
(2) On the Web UI (Optical Disc Archive Library Maintenance Web UI) drive setting tab of ODS-L30M, restart
the drive whose serial number is not shown.
(3) After about one minute has passed after restart, perform Check (1) and Check (2) again and check the
indication of Device Manager.
2.
Disabling/enabling in Device Manager:
(1) Disable the fibre channel HBA by Device Manager, and then enable it.
(2) After about one minute has passed after the fibre channel HBA is enabled, perform Check (1) and Check (2)
again and check the indication of Device Manager.
Note
Connected equipment may be hung up. Before taking this measures, close the upper applications.
3.
After about one minute has passed after the connected equipment is restarted, perform Check (1) and Check (2)
again and check the indication of Device Manager.
ODS-D280U/ODS-D280F
Check (1):
SONY ODS-D280F SCSI Optical Device
Check (2):
Fibre channel HBA product name
1-8
Advertisement
Table of Contents
