Ca Motor (V) Assembly - Sony ODS-D280U Service Manual

4-13.

CA Motor (V) Assembly

Required item
• Grease FLOIL (FLOIL G-902)
Tip
The following part cannot be reused. Prepare the new part.
• Tape AS: 1 pc
Preparation
1. Remove the top cover assembly. (Refer to
2. Remove the MC top reinforcing plate. (Refer to
3. Remove the power supply block. (Refer to
Procedure
1. Disconnect the harness and cables.
(1) Open the two clampers, then disconnect the harness from the connector (CN2) on the SM-45 board.
(2) Disconnect the flexible flat cable from the connector (CN61) on the SM-45 board.
(3) Disconnect the flexible flat cable from the connector (CN50) on the SM-45 board.
(4) Remove the tape AS.
Harness
(with shrinkable tube)
Flexible flat cable
a
CN61
SM-45 board
Note
Be careful not to damage the flexible flat cable when handling it.
ODS-D280U/ODS-D280F
"4-2. Top Cover
"4-4. MC Top Reinforcing
"4-8. Power Supply
Tape AS
Flexible flat cable
a
CN50
CN2 Clamper
Assembly".)
Plate".)
Block".)
Tape AS attaching position
Tape AS
CA motor (V) assembly
CA motor (V) assembly
Upper side
Clamper
Rear side
4-33