4.
Carry the disc.
(1) Rotate the CA gear (UPPER) (large) of the CA motor assembly until you do not feel any load. (At this time,
most part of the disc is inserted in the slot of the cartridge.)
Note
If the load when rotating the CA gear (UPPER) (large) is large (unable to rotate), the positioning of the load
disc of the select loader may be inadequate. Check the positioning procedure in the previous section again.
CA gear (upper) (large)
CA motor assembly
ODS-D280U/ODS-D280F
CA transmission gear
CA motor (V) assembly
Rear side
CA side slider R
Locate the bearing in this position.
CA side slider R
1-21