Nice E FIT SP 611 Instructions And Warnings For Installation And Use page 9

4.11 - Total or partial deletion of memory
This procedure allows you to choose under point 5 the data that you want to delete.
Procedure performed with a transmitter memorized in "Mode 1"
1
= 5 sec
2
Keep the button count 2 movements
pressed
3
= 5 sec
3
Keep the button count 3 movements
pressed
4
= 5 sec
3
Keep the button count 3 movements
pressed
ATTENTION!
This deletion must be performed only when
you want to adjust the limit switch heights
again, using a different procedure than the
one used previously. Whereas if you want to
adjust heights with the same procedure, it is
not necessary to delete them from memory.
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
2
= 5 sec
release the button Keep the button
pressed
 4
• To cancel the entire memory
release the button
 5
• To delete only the memorized transmitters
release the button
• To delete only the limit switch heights and intermediate heights
3
count 3 movements release the button
5
= 5 sec
5
Keep both buttons count 5 movements
pressed at the
same time
5
= 5 sec
5
Keep the button count 5 movements
pressed
5
5
Keep the button count 5 movements
pressed
 3
the end
release the buttons
the end
release the button
the end
English – 8 English – 8