Nice E FIT SP 611 Instructions And Warnings For Installation And Use page 8

4.10 - Memorizing a SECOND (third, fourth, etc.) transmitter
To perform this procedure you must have a second transmitter ("old") already memorized.
4.10.1 - Memorizing a second transmitter "Mode 1"
Attention! – This procedure memorizes the new transmitter in "Mode 1", regardless of the Mode in which the old to transmitter was memorized.
1
New
New transmitter keep the button pressed
3
New
New transmitter press and release the
button
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
4.10.2 - Memorizing a second transmitter "Mode 2"
Attention! – This procedure memorizes the new transmitter in "Mode 2", regardless of the Mode in which the old to transmitter was memorized.
1
New
New transmitter keep the button pressed
3
(x ...)
Old
Old transmitter press and release the button the same number of times as per the
selected option
4
New
New transmitter keep the button pres-
sed
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
7 – English 7 – English
= 8 sec
Release the button (in
this case the motor
does not perform any
movement)
= 0,5 sec
Attention! – If the motor per-
forms 6 movements, it means
that its memory is full.
= 8 sec
release the button
4 OPTIONS:
1 pressure = sets the Step-by-Step command
2 pressures = set the Open > Stop > ... command
3 pressures = sets the Close > Stop > ... command
5 pressures = sets the Stop command
= 5 sec
3
count the movements
2
= 0,5 sec
Old
Old transmitter Press and release any button 3 times, on condition it
is stored (the motor starts to perform the manoeuvre
corresponding to that button)
the end
2
= 5 sec
Old
Old transmitter keep the button pressed
10
sec.
wait ...
Attention! – If the motor
performs 6 movements, it
means that its memory is full.
release the button
 3
(x 3)
4
count 4 movements release the button
1 /
2 /
?
3 /
4 /
the motor performs the same number of movements as
the number of times the transmitter has been pressed
the end
 3
 4