Nice E FIT SP 611 Instructions And Warnings For Installation And Use page 6

Tubolar motor

Table of Contents

Available languages

4.8 - Enabling automatic High ("0") and Low ("1") limit switch recognition

This procedure matches the motor rotation direction with the s and t keys on the control device, so that the s key raises the rolling shutter and the t key lowers it.

Limit switches will be automatically programmed later on during the first 2-3 manoeuvres for opening and closing the rolling shutter.

WARNINGS

• When the limit switches are memorized with this procedure, the two heights are controlled and updated constantly by the "limit switch self-update" function (see

paragraph 5.3).

= 5 sec

Bring the shutter

Keep the button

up for half its

pressed

stroke

= ... sec

Select the

desired

option



Press the button and then proceed as per the

selected option

Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press

any key and wait 60 seconds for the motor to perform 6 movements.

After completing the procedure, command a manoeuvre to check that the key pressed corresponds to the right direction of shutter movement. If it

does not correspond, perform procedure 4.8.1 to reset the original settings and then repeat procedure 4.8.

Note – After programming, the s key will command the Raise motion and the t key will command the Lower motion. The shutter will move within the limits created

by the mechanical blocks of the limit switches.

4.8.1 - Disabling automatic recognition (for maintenance or restoration of factory settings)

= 5 sec

Bring the shutter

Keep the button

up for half its

pressed

stroke

5 – English

ATTENTION! – Programming intended exclusively for rolling shutters with mechanical blocks for the limit

switch.

count 2 movements