Preparing For Operation - OM POWER OM2000+ Manual

5.3 Preparing for operation

In STBY the amplifier is in bypass-mode and your transceiver is directly connected to the
antenna. Maximum allowed power in bypass mode is 200 Watts! The bypass RF power is
displayed if PA is in standby mode.
To turn PA ON press ON/OFF button on the front panel (black one) and hold it abt. 1 second. PA will start
tube heating. It will take 180 seconds. Turning PA ON is possible ONLY from the home screen! If you have
other display active, press EXIT to go back to the home screen.
UPGRADE touch button should ONLY be
Type of supported TCVR and working
used if the EPROM or firmware files (or
both) will be upgraded. In such a case see
frequency are visible on the display.
page 29.
The "Tube Heating Timer" is visible on the
Type of supported TCVR and working
display. Wait until the required 180 seconds
is complete before placing the amplifier in
frequency are visible on the display.
OPERATE Mode.
After heating is completed, the PA will light
Type of supported TCVR and working
the STBY mode indicator and this Main
display will appear.
frequency are visible on the display.
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
17