Om2000+ Control - OM POWER OM2000+ Manual

-
OPR/STBY
Short press for switching between STBY and OPERATION mode.
-
ON/OFF
Long press (hold for a 1 sec.) for switching the PA ON (first start to tube heating), 2
seconds for PA OFF. Always first use the ON/OFF push button as this allows for a predetermined
(software controlled) time to cool down the tube and inside the PA compartment.
5.2.

OM2000+ control

Turn ON the green Main Power switch and the home screen lights up. Initial control touch buttons are
visible on the bottom line.
Remember that the touch screen is active for
some information, while the PA is still OFF!
Type of supported TCVR and
frequency are visible on the
AUTO LED is ON.
Information display shows basic information
about the PA: serial number, software
version, time ON, tube serial number and
Type of supported TCVR and
nominal mains voltage.
The information screen also provides an
frequency are visible on the
overview of the last 20 warnings and faults.
AUTO LED is ON.
Press FAULTS.
Type of supported TCVR and
Press EXIT to go back to the home screen. frequency are visible on the
AUTO LED is ON.
working
display.
working
display.
working
display.
13