OM POWER OM2000+ Manual page 21

We selected last 20 FAULTS to show.
Type of supported TCVR and working
frequency are visible on the display.
Press EXIT
Go to SET EBS1 AUTO and press SET.
PA will automatically set 20mA on the tube.
Type of supported TCVR and working
When finished successfully, you will see SET
frequency are visible on the display.
EBS1 AUTO OK on the screen
You can try to do this manually, too.
Scroll to SET EBS1 MANUAL and press SET.
Type of supported TCVR and working
Use up/down buttons to set 20mA or as close
frequency are visible on the display.
as possible value and press SAVE.
Similar ways EBS2 can be preprogrammed
( 300 mA FU-728F).
Or another value of EBS2 by MANUAL Set.
Scroll to CALIBRATION Ip, Is and press SET.
Calibration will be done automatically.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
21