Table of Contents
Advertisement
Jitter Delay
Enable Video
H.264 payload type
H.263+ payload type
H.263 Default Resolution
Enable RFC5168 Support
SRTP Mode
Special Feature
FXO S
ETTINGS
The FXO tab would only appear for GXV3005.
T
14: FXO C
ABLE
ONFIGURATION
Current Disconnect
Enable Tone Disconnect
Grandstream Networks, Inc.
Select desired Jitter Buffer Delay. Default is Medium. It is using 100, 200 and 400ms to
match the setting of low, medium and high for audio. The video always buffered and played
in synchronize with audio.
Grandstream recommends "High" for a poor network environment.
Yes: video is enabled for all calls. This is the default value.
No, but allow in-call enabling :
Receiving call:
There are two ways to pick up incoming video call.
-Pressing SPEAKER or picking up handset will answer the call as VOICE ONLY call.
GXV300x can still send out video request after the call is established by pressing MIR-
ROR button.
-Pressing MIRROR button will answer the call as VOICE & VIDEO call.
Making call:
-Picking up handset or pressing SPEAKER
-Pressing MIRROR button to toggle between VOICE ONLY and VOICE & VIDEO
No: video is disabled.
Enter a desired value (96-127) for dynamic RTP payload type of H.264 codec.
Default is 99.
Enter a desired value (96-127) for payload type of H.263+ codec. Default is 103
Default is CIF.
Default is No.
If it is set to Yes, phone will send an SIP INFO asking for update of I-frame.
Enable SRTP mode based on selection. Default is Disabled.
Default is Standard.
Choose the selection to meet special requirements from different Soft Switch vendors (like
Nortel, Broadsoft, Sonus, etc)
P
D
AGE
EFINITIONS
This is a preconfigured value of duration for a line power drop used by specific service pro-
viders. For example, for a configured value of 500ms the device will ignore any random
voltage drops on the line if duration of such drop is less than 500ms and the call will NOT
be considered as terminated. This is useful to prevent unnecessary call drops in some low
quality PSTN lines.
Default is Yes. If set to Yes, busy tone is used as disconnect signal.
GXV300x User Manual
Firmware 1.2.3.7
Page 36 of 54
Updated: 12/2010
Advertisement
Table of Contents
