Grandstream Networks GXV300x Series User Manual page 30

Video Frame
Skipping the bad video frame received
Skipping
Default is No.
Sharpening Filter
Sharpening filter for incoming video. Default value is 5
Brightening Filter Brightening filter for incoming video. Default value is 5
Tone Remapping Default value is 32. It can be used to improve video quality under low light conditions by equalizing
Filter (remapping) colors/tones.
Tone Remapping Filter can also be adjusted after video conversation is established.
- Use MWI button
mode.
- After choosing the feature, use UP and DOWN arrow to adjust.
Packetization- Default is 0.
mode
Enable Video Default is No. If configured to YES, the video phone can be turned to a video surveillance camera
Surveillance after the phone rebooted.
Surveillance
This is the port for the video surveillance camera data stream.
RTSP port
Default is 554.
Streaming RTSP
This is for the URI of the streaming RTSP server.
Server
GXV300x can also be a remote surveillance monitor for another GXV300x phone used as surveil-
lance camera or other supported IP Camera or video source. For such application, both devices
(Server and Monitor) have to be in the same LAN or VPN.
Streaming RTSP The user ID used to connect to RTSP server.
User ID To act as remote surveillance monitor, the GXV300x has to give the RTSP server authorized User
ID in order to fetch the RTSP streaming packets.
Streaming RTSP
The password used to connect to RTSP server.
Password
To act as remote surveillance monitor, the GXV300x has to give the server authorized Password
to match the credentials in order to fetch the RTSP streaming packets.
Layer 3 QoS
This field defines the layer 3 QoS parameter.
It is the value used for IP Precedence or Diff-Serv or MPLS. Default value is 0.
Layer 2 QoS This contains the value used for layer 2 VLAN tag (802.1q and 802.1p). Default setting is blank.
No Key Entry
Default is 4 seconds. User can press SEND key (or # key if configured) to overwrite the 4 seconds
Timeout value to speed up dialing
Use # as This parameter allows users to configure the "#" key as the "Send" (or "Dial") key.
Dial Key If set to "Yes", the "#" key will immediately send the call. In this case, this key is essentially
equivalent to the "(Re)Dial" key. If set to "No", the "#" key is included as part of the dial string.
Local RTP port This parameter defines the local RTP-RTCP port pair used to listen and transmit. It is the base
RTP port for channel 0. When configured, for audio, channel 0 will use this port _value for RTP
and the port_value+1 for its RTCP; channel 1 will use port_value+4 for RTP and port_value+5 for
its RTCP. For video, channel 0 will use port_value+2 for RTP and port_value+3 for its RTCP;
channel 1 will use port_value+6 for RTP and port_value+7 for RTCP. The default value is 5004
Grandstream Networks, Inc.
to toggle between VOLUME, BIT RATE, and Tone Remapping Filter
GXV300x User Manual
Firmware 1.2.3.7
Page 28 of 54
Updated: 12/2010