Description Of The Device; Installation; Set Up And Operation; 100V Mode - DAPAudio PR-52T Manual

PR-52T

Description of the device

Features
 Power taps: 16 Ω, 2/4/8/15W
 Woofer: 5,25" mica cone rubber edge
 Tweeter: 13 mm mylar dome
 Frequency: 50 Hz - 20 kHz
 Built-in 100V transformer
 Sensitivity: 89 dB
 Connections: speaker cable connector IN
 Color: Black (D3533), White (D3534)
 IP rating: IP20
 Dimensions: 170 x 180 x 240 mm (LxWxH)
 Weight: 4,6 kg

Installation

Remove all packing materials from the PR-52T. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

100V Mode

01) Use a screwdriver to select the desired power tap: 2/4/8/15W.
02) Connect the common cable from your 100V amplifier to the black connector.
03) Connect the main feed cable from your 100V amplifier to the red connector.

Conventional Amplifier Mode

01) Use a screwdriver to select the 16 Ω power tap.
02) Connect the common cable from your conventional amplifier to the black connector.
03) Connect the main feed cable from your conventional amplifier to the red connector.

Maintenance

The DAP Audio PR-52T requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.

Troubleshooting

No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer's instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
If the speakers do not operate properly, refer servicing to a technician.
Suspect two potential problem areas as: the power supply and the speakers.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The speakers. Return the PR-52T to your DAP Audio dealer.
03) If both appear to be O.K., plug the unit in again.
Ordercode: D3533/D3534
5