Motocaddy S1 Instruction Manual page 17

Battery Meter / USB Charging Port
Battery Meter
The S1 includes an on-screen battery meter which provides an indication of remaining battery capacity.
The number of illuminated bars will decrease as the battery capacity reduces.
A fully charged battery will show from left to right - two short red bars, two medium orange bars and
two larger green bars (fig. 1).
The trolley is designed to protect your battery from being fully discharged, should your battery capacity
drop too low the trolley will cut the power to the motor. If this should happen, please charge your Lithium
battery before further use. It is possible to use the outer "free-wheel" groove to complete your round if required.
Please be aware that certain moisture, temperature and humidity conditions can result in localised
misting within the display screen. This will not affect the trolley functionality, nor cause any damage
and will return to normal when adverse conditions subside.
USB Charging Port
Fig 1
This trolley features a USB charging port designed to charge USB powered devices during your round.
Simply remove the covering cap and plug a USB cable into the charging port located on the underside of
the handle. The device will continue charging while the cable is attached and the battery is connected.
The rate of charge will be slower than a mains AC charger and similar to plugging the device into a PC.
The USB charger takes power from the main trolley battery and continuous charging will reduce the
battery capacity between charges. The trolley is designed to disable the USB port when the battery
capacity reaches a preset level.
Page 17