Table of Contents
Advertisement
Description of Buttons and Switches
Control panel
1
1
POWER switch - to turn the rocker ON (power switch illuminates) or OFF.
2
SPEED knob - to set the rocker speed.
3
TIME knob - to set the time of operation.
4
HOLD yellow signal light - illuminates when the rocker is set to HOLD (continuous operation).
5
START/STOP key - to START or STOP the rocking operation.
6
RUN green signal light - illuminates when the rocker is running.
Operation
1. Turn POWER switch ON (it should illuminate).
2. Set SPEED knob to desired value.
3. Set TIME knob to desired value or to HOLD - continuous operation (yellow signal light HOLD must
illuminate).
4. Press START/STOP key to start the rocking operation.
5. Device automatically stops after the set time passes.
6. If you want to stop the rocking operation before the set time passes, or when TIME knob is set to
HOLD, press START/STOP key.
NOTE:
Pressing START/STOP key during operation will reset the timer.
It's possible to change speed during operation, but you cannot change time. If you want
to change time, stop the rocker, set desired time and start it again.
Do not put your hands between platform and housing during operation, because your
fingers can get crushed.
2
3
4
5
6
6
Advertisement
Table of Contents
