Table of Contents
Advertisement
Getting Started
Adjusting tilt angle
Before you adjust the tilt angle, unplug power cord from power supply!
A
B
1. Unscrew two wing nuts (A) from the cover (B) on the back side of the rocker and remove the cover (B).
2. Unscrew the screw (C) at the end of the shaft.
3. Find the hole with desired tilt angle inscription on the disk (D) and screw the screw (C) in that hole.
4. Put the cover (B) back on and fix it by screwing back two wing nuts (A).
Now the rocker is ready for operation with new tilt angle.
Installation of double platform
Before the installation of double platform, turn off the POWER switch.
For installation of double platform, prepare upper platform with rubber pad and posts kit, which includes
four posts, four washers, four screws and four nuts.
Posts kit
E
A
B
C
A
E
D
A
B
C
7
Advertisement
Table of Contents
