Mercedes-Benz AMG GT 4-door coupe Owner's Manual page 333

Hide thumbs Also See for AMG GT 4-door coupe:
Table of Contents

Advertisement

330 Breakdown assistance
Let the tyre inflation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre
pressure of at least 200 kPa (2.0 bar/
29 psi).
If tyre sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera‐
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy‐
lene.
If, after ten minutes, a tyre pressure of
200 kPa (2.0 bar/29 psi) has not been
attained:
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
Please note that tyre sealant may leak out when
unscrewing the filling hose.
Drive forwards or in reverse very slowly for
#
approximately 10 m.
Pump up the tyre again.
#
After a maximum of ten minutes the tyre
pressure must be at least 200 kPa (2.0 bar/
29 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being
attained
If the minimum tyre pressure is not reached
after the specified time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
The braking and driving characteristics may
be greatly impaired.
Do not continue driving.
#
Consult a qualified specialist workshop.
#
If, after ten minutes, a tyre pressure of
200 kPa (2.0 bar/29 psi) has been attained:
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
& WARNING Risk of accident from driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
impairs the handling characteristics and is
not suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed
#
limit with a tyre that has been repaired
using tyre sealant.
Observe the maximum permissible speed for
#
a tyre sealed with tyre sealant 80 km/h.
* NOTE Staining from leaking tyre sealant
After use, excess tyre sealant may leak out
from the filling hose.
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.

Advertisement

Table of Contents
loading

Table of Contents