Mercedes-Benz AMG GT 4-door coupe Owner's Manual page 196

Hide thumbs Also See for AMG GT 4-door coupe:
Table of Contents

Advertisement

If the last stored speed has previously been
deleted, the current vehicle speed is stored.
%
When you switch off the vehicle, the last
speed stored is deleted.
When you activate cruise control or Active
Distance Assist DISTRONIC, the last speed
stored for the variable limiter is deleted.
Increasing/decreasing the stored speed
To increase the stored speed: swipe upwards
#
from the bottom of control panel 1.
The stored speed is increased by 1 km/h.
R
To decrease the stored speed: swipe down‐
#
wards from the top of control panel 1.
The stored speed is decreased by
R
1 km/h.
or
Briefly press M or N on control panel
#
1.
The stored speed is increased or decreased
to the next increment of ten (e.g. to 50 km/h
or 60 km/h).
or
Press and hold M or N on control
#
panel 1.
The stored speed is increased or decreased
to the next increment of ten and afterwards
by increments of 10 km/h.
or
Accelerate the vehicle to the desired speed.
#
Press M on control panel 1.
#
%
When the variable limiter is switched to pas‐
sive mode, you cannot increase or decrease
its stored speed in increments of 1 km/h.
Adopting a detected speed
If cruise control/variable limiter is activated and
Traffic Sign Assist has detected a speed restric‐
tion sign with a maximum permissible speed and
this is displayed in the instrument cluster:
Press J.
#
The maximum permissible speed shown by
the traffic sign is stored and the vehicle
maintains or does not exceed this speed.
Deactivating cruise control or the variable
limiter
Driving and parking 193
Press ±.
#
%
If you brake, deactivate ESP
intervenes, cruise control is deactivated. The
variable limiter is not deactivated.
Information on the permanent limiter
If the vehicle should never exceed a specific
speed (e.g. for driving in winter tyre mode), you
can set this speed with the permanent limiter.
You do this by limiting the speed between
160 km/h and 240 km/h in the multimedia sys‐
tem (
page 194).
/
Shortly before the set speed is reached, it
appears in the multifunction display. When you
confirm the message, display messages no lon‐
ger appear until you switch off the vehicle. The
speed will only be displayed again once the vehi‐
cle has been restarted or if the set speed is
changed.
The permanent limiter does not switch to pas‐
sive mode even during kickdown and the driven
speed remains below the set speed.
®
®
or if ESP

Advertisement

Table of Contents
loading

Table of Contents